Blog
Latest Posts #Software Development
A Woodworkers Perspective (Part 5): Make it a Habit
Series: A Woodworkers Perspective
Join me as I share some of my thoughts on software development through the lens of woodworking.
2019-04-01
#Software Development #Woodworking
A Woodworkers Perspective (Part 4): Don’t Be A Hero
Series: A Woodworkers Perspective
Join me as I share some of my thoughts on software development through the lens of woodworking.
2019-03-15
#Software Development #Woodworking
A Woodworkers Perspective (Part 3): Every Cut Counts
Series: A Woodworkers Perspective
Join me as I share some of my thoughts on software development through the lens of woodworking.
2019-03-01
#Software Development #Woodworking
A Woodworkers Perspective (Part 2): Use Your Resources
Series: A Woodworkers Perspective
When building this box I needed to have a slot for the back and front panels to slide into. There are multiple ways to do this. Adjust the blade of the table saw, use an electric router, a router plane, and if nothing else slowly chisel a line until it works. Obviously, the first two options are typically preferred, set the blade and rip the board — It takes almost no time. The same goes for the box joints. A little setup with a router and ***boom*** done.
2019-02-15
#Software Development #Woodworking
Blog Archive